shark duo clean vacuum brush roll indicator light green

#Shark duo clean vacuum brush roll indicator light green free

You will need to allow the battery to cool down before attempting to recharge it. Either it’s not holding a charge or there’s a problem with the charger.

If the carpet and floor lights are flashing together, there’s a problem connected to the battery.

If both of these lights are flashing it can mean one of two things: Most Shark vacuums have specific lights for carpets and hard floors, these lights will flash to indicate a problem of some sort. Check to see that the brush roll is spinning, if not check that you have switched the brush roll activation mode to on. Then check the floor setting is set to carpet mode. You should hear a click to indicate it’s closed properly. Once you’ve finished cleaning the brush roller, make sure the door is pushed back into place correctly. Flashing white headlights usually indicates a jam and the brush roll stops spinning also.Ĭheck the brush roller by removing the door above the brush roller by pressing the buttons on the roller head. If they start to flash it usually indicates some sort of problem. If your Shark vacuum has headlights they’ll be located on top of the vacuum head and they’re used to light up the area in front of the vacuum so you can see the area to clean. If a Shark vacuum has been operating for a long period of time the motor can overheat which is common practice and nothing to worry about as long as you allow it time to cool down before restarting it.

If, after the 45 minute cool down period, the vacuum starts working again, then it was overheating and you’re now fine to proceed. If you suspect the problem is overheating, you should turn it off and allow at least 45 minutes before trying it again. If you’ve been vacuuming for a while and the red light starts to flash it almost certainly indicates the vacuum is overheating. The belt drives the brush roll so any problem with the belt will result in the brush roll not operating correctly.

You’ll need to remove all of this debris by hand (scissors will help if you’re careful not to damage the roller or vacuum in any way).Įither the belt is stretched, damaged, broken or sometimes just has something caught in it that obstructs the correct movement of the belt. The roller can get clogged with hair, string, cotton, carpet strands or just general stringy dirt and debris. Every time you vacuum you run the risk of jamming the brush roller. If the appliance won’t start or stops immediately after starting, it’s likely to be the brush roller that’s causing the problem. Any time you see a red flashing light it’s indicative of a problem, however, it doesn’t signify a specific problem and could mean one of the following Red Flashing LightĪ red light means danger or in this case a problem with your Shark vacuum.

#Shark duo clean vacuum brush roll indicator light green free

When the green light is visible you are free to vacuum at will. The green light indicates the power is on and everything is working as it should. Once it’s fully charged you will see a continuous blue light. Blue flashing lights are normal when your cordless Shark vacuum is charging. These are charging lights and indicate that the vacuum is currently charging. Frequently Asked Questions Blue Flashing LightsĪs soon as you connect a cordless Shark vacuum to the charger and turn on the power from the wall socket, blue coloured lights flash on and off at a slow rate.What To Do If The Lights Are Still Flashing On Your Shark Vacuum.Check The Connection Between The Wand And Hand Vac.Regular Maintenance Can Prevent Many Problems.What Do The Lights Indicate On A Shark Vacuum?.